Macpower Alumni Manuál s instrukcemi stáhnout pdf (Strana 32)

SVAT ELECTRONICS

now you can see

CLEARVU11

MAIN MENU

The following is a brief description of each item and its specic operations:

• Size (GB) – the total HDD storage in GB (Giga-Byte) for Alarm Record and Normal Record respectively. This item

is just for information. Please refer to the section on HDD format/clear for detailed information and setup.

• Auto Overwrite – allows you to automatically overwrite the recorded video/audio from HDD#1 when the

Alarm/Normal Record disk drive capacity is full. If Auto Overwrite is disabled and the Alarm/Normal Record disk

drive capacity reaches the end, the system will not overwrite the recorded video/audio, and hence not record

Alarm/Normal video/audio, until the user presses the Alarm Reset button. Press ENTER or +/- to check/

uncheck this item. The default setting is “” - checked.

• HDD Full Action –Activates certain actions when Alarm/Normal Record disk drive capacity reaches the end of

the last HDD. Press ENTER or +/- to check/uncheck this item. The default setting is “” - checked.

• Duration – response duration to dene how long (in seconds) the Alarm Out relay and the Buzzer will keep

being triggered after the corresponding selection, Alarm Record or Normal Record, is full. Press +/- buttons to

adjust the value (3-60 seconds, discrete).

• Alarm Out – to dene which Alarm Output will be triggered when the corresponding selection, Alarm Record

or Normal Record, is full. Press +/- buttons to select none (N/A) or one of the Alarm Outputs (1-2).

• Buzzer – to activate the internal Buzzer or not when the corresponding partition, Alarm Record or Normal

Record, is full. Press ENTER or +/- to check/uncheck this item. The default setting is “” - checked.

• Log – to log to event logs or not. Press ENTER or +/- to check/uncheck this item. The default setting is “” -

checked.

• E-mail – to send the event e-mail to a pre-determined email address or not. The e-mail will be sent to the

predened receivers when the event is triggered. Press ENTER or +/- to check/uncheck this item. The default

setting is “–” - unchecked.

The general operations are as below:

• ▲▼◄►- Press these buttons to select the items.

• MODE - Format/Clear - Press this button to format/clear the HDDs as described in the next section.

• ESC (MENU/ESC) - Press this button to escape from this screen, and return to Setup Menu display. If the Save

dialog is shown, press ENTER to exit and save, ESC (MENU/ESC) to exit without saving.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 73 74

Žádné komentáře

Macpower Alumni Manuál s instrukcemi Strana 32