Macpower Alumni Manuál s instrukcemi stáhnout pdf (Strana 27)

SVAT ELECTRONICS

now you can see

CLEARVU11

MAIN MENU

The general operations are as below:

• ▲▼◄►- Press these buttons to select the items. The display will scroll left/right if the selected item is not

shown on the screen.

• Numeric (CH1-CH4) - Press these buttons to select the camera.

• COPY ( ) - Press this button to copy all the settings - excluding detailed Motion settings, Video Loss

settings, Title/Audio - of the focus camera to all the following cameras. (E.g. focus camera is 1, its settings will

be copied to those of cameras 2-4.)

• ESC(MENU/ESC)-Press this button to escape from this screen, and return to Setup Menu display. If the Save

dialog is shown, press ENTER to exit and save, ESC (MENU/ESC) to exit without saving.

ALARM SETUP

In Setup Menu display, press ▲▼

to change the highlighted option

to Alarm, and then press ENTER

to call up Alarm Setup display as

shown. The Alarm Setup allows

the administrator to dene the

attributes for each alarm input, and

the actions if it’s triggered. There

are up to 4 alarm inputs which can

be connected to the system.

Following is a brief description for each item and its specic operations:

• Normal State – press +/- buttons to select N/A, Close or Open. Please check the signal type, normally close or

normally open, connected to the alarm input terminal on the rear panel of the system. If there’s no signal connected,

please select N/A – Not Available, and the following items will not be setup. The default setting is Open.

• Focus Camera – the camera corresponding to this alarm input.

• Duration – response duration to dene how long (in seconds) the Alarm Out relay and the Buzzer will stay on for

after this alarm input is triggered. However, the Alarm Out relay and the Buzzer will be reset immediately once this

alarm input returns to normal. Press +/- buttons to adjust the value (3-60 seconds, discrete).

• Goto Preset – to dene the preset position to go to for the Focus Camera if this alarm input is triggered (only

available for PTZ cameras).

• Pre-record – to dene how long before this alarm input is triggered the Focus Camera will be recorded at pre-

record IPS. Press +/- buttons to adjust the value (0-10 seconds, discrete). Please note that the actual pre-record

time may be shorter than the value set if the total size of the pre-record pictures exceeds the pre-record buer size

of the system.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 73 74

Žádné komentáře

Macpower Alumni Manuál s instrukcemi Strana 27